Skip to content

Why two sauna gauges show different numbers

Last checked November 16, 2026

Two gauges almost never agree to the digit. A small gap is normal, and a large one is a clue. The causes fall into a few groups.

Different designs read differently

A dial and a digital gauge sense heat in different ways. A bimetal dial relies on two joined metals that expand unequally.1 A digital one reads an electronic sensor. Each has its own way of drifting from the true value, so one can read a bit higher than the other.

See Sauna thermometer types for how each type works.

Every gauge has a tolerance

Tolerance is the amount of error a maker accepts. The measuring equipment manufacturer generally assigns the measurement tolerance.2 Two models from two makers can therefore sit on opposite sides of the true value and both be within spec.

Hygrometers carry this more heavily. One reference says a capacitive sensor that's uncalibrated has an error two to three times worse than a calibrated one.3 Don't expect two humidity dials to match closely.

Knocks and heat shift the reading

Dials can drift. A kitchen-thermometer guide from North Dakota State University says thermometers can get out of adjustment if they are jarred.4 It adds that dropped ones, or ones exposed to extremes in temperatures, should be calibrated.4 The guide is about food thermometers. The lesson carries over in a general way: a gauge that took a fall may not read what it did before.

Humidity depends on temperature

A humidity gap can be real even when both gauges work. Warming air decreases the relative humidity.5 If one hygrometer sits in warmer air than the other, it will read lower. That's physics, not a fault.

Different gauges sit in different places

A wall dial and a heater's own control sensor are different parts with different jobs. Harvia's sensor for its heaters, for example, can be mounted on the wall or ceiling.6

So the number on a control panel can differ from the number on a separate gauge. Don't move a heater's sensor to make the numbers match. Check the heater's operating instructions for the correct sensor.6 Also check where it is to be mounted. If the heater is hard-wired, any change to it is a job for a licensed electrician.

Where a gap between two gauges comes fromDifferent sensor designsDifferent tolerances from the makerDrift after knocks or heatDifferent spots in the room
Each step can add a little difference.

What to do about a gap

First, work out which kind of gap you have. A small, steady gap between two different designs fits the causes above. A gap that grows, or a gauge that changed after a drop, is worth checking. The page on checking a gauge walks through a simple comparison.

If a gauge reads far off, the maker's manual says what repair or adjustment is allowed for that model. Some can't be adjusted at all.

Reference list

  1. Thermometer, Wikipedia
  2. Calibration, Wikipedia
  3. Hygrometer, Wikipedia
  4. Keep Hot Foods Hot and Cold Foods Cold: A Foodservice Guide to Thermometers and Safe Temperatures (FN712), North Dakota State University Extension
  5. Relative humidity, Wikipedia
  6. Harvia temperature sensor 125 Celsius without cable (SP248), Harvia