Skip to content

How to check a sauna thermometer against a reference

Last checked November 16, 2026

A reference thermometer is one you trust more than the gauge you're testing. Checking means putting the two in the same conditions and comparing what they say. Wikipedia describes calibration as the comparison of measurement values from a device under test with those of a calibration standard of known accuracy.1

What counts as a reference

In a lab, the reference is a precision instrument. Wikipedia gives one example: a platinum resistance thermometer with a digital display.2 You won't need that for a home sauna.

At home, a reference just needs to be a second thermometer you've got good reason to trust, and one that's rated for the heat by its own maker. If you can't confirm the rating, don't put it in the room.

Method one: side by side

The simplest check needs no water. A university extension guide covers refrigerator thermometers this way: place the thermometers side by side and compare readings.3

The same idea works in a sauna. Hang or set the reference close to the gauge, at the same height and wall position. Let the room warm up and hold steady. Then read both. Read them at the same moment, and read them more than once.

Two cautions. Keep your face and hands clear of hot surfaces while you read. And don't move a heater's own control sensor to line things up. That sensor is a safety part, and its position comes from the heater's manual. A hard-wired heater is a job for a licensed electrician.

A side-by-side checkPick a trusted reference thermometerPlace both in the same spotWait until both readings settleCompare and note the gap
Compare under the same conditions, then judge the gap.

Method two: the ice point

Water freezes at a fixed point, so an ice bath makes a convenient fixed reference. The extension guide describes it for stemmed food thermometers: make a thick ice slush from crushed ice and cold water in equal parts.3 Insert the sensing end into the middle of the slush and wait for the reading to settle. The guide says the indicator should then read 32 F (0 C).3

That's a method for a stem thermometer with a metal sensing end. Plenty of sauna gauges have wooden cases or electronics that shouldn't get wet. The guide says nothing about sauna gauges. So read the maker's manual first. If it doesn't say the gauge can go in water, don't do it.

There's another limit. A gauge whose scale starts well above freezing can't show the ice point at all, so this check won't work on it.

Reading the result

If the two readings are close, the gauge is probably fine for general use. If they differ by a lot, repeat the check first. Then look at the gauge's own manual for a way to adjust it.

Some dials have a calibration nut. The guide says to adjust the nut so the indicator reads 32 F (0 C) in the slush.3 Many sauna gauges don't have one. For those, a large error means a replacement. The guide notes that some inaccurate thermometers usually cannot be recalibrated and must be replaced, which it says about refrigerator and freezer models.3

A hygrometer needs a different kind of check, and this page doesn't cover one. Humidity gauges depend on temperature as well, so a gap can have more than one cause. Causes of a gap are listed in Why gauges disagree. Humidity is explained under Hygrometers.

Reference list

  1. Calibration, Wikipedia
  2. Thermometer, Wikipedia
  3. Keep Hot Foods Hot and Cold Foods Cold: A Foodservice Guide to Thermometers and Safe Temperatures (FN712), North Dakota State University Extension